Bollard Skyllermarks (-) S (35/50 mm2)

Skyllermarks Terminal block - Terminal block (S) 35/50 mm . To connect your cables to the battery terminals, Skyllermarks has developed the terminal block. It is a terminal block and terminal shoe in one. Screws and washers are made of stainless steel (A2). On the terminal block you can put up to four coarse cables without them touching each other. This allows you to tighten them properly and avoid voltage drops. All contact surfaces are milled flat and the entire terminal is made of tinned brass. All screws, washers and nuts are made of stainless steel. All Skyllermark terminal blocks are made in Sweden. Maximum dimension 50 mm . Cable connection 4xM6. For best function: Only use one cable per screw. If the fixing points are not sufficient, run one cable to a terminal block and then several cables from there. Tighten the cables firmly! Mount carefully on the lead pole. Press down firmly, but do not over tighten.