Victron Blue Smart IP65 charger 24V 8A 230V

Victron Blue Smart IP65 24v 8A. Battery charger with Bluetooth built in! This allows you to view the information from the charger on your smartphone, tablet or computer using the VictronConnect app. The charger has two power modes 8A and 3A. The 3A mode is activated by pressing and holding the mode button until the LED indicator for the selected mode starts flashing. - Water, dust and chemical resistant - Seven-step smart charging algorithm - Recycling of fully discharged, dead batteries - Automatic power supply function - Severe cold performance: down to -30 C - Multiple life-enhancing features - Low power setting to charge smaller batteries - Lithium-ion battery mode - Setup and configuration, voltage and current readout with Bluetooth Smart Ultra-high efficiency green battery charger: With up to 95% efficiency, these chargers generate up to four times less heat compared to industry standards. And once the battery is fully charged, power consumption is reduced to 0.5 watts, about five to ten times better than industry standards. Durable, safe and quiet: - Low thermal stress on electronic components; - Protection against ingress of dust, water and chemicals; - Overheating protection: the output current is reduced as the temperature increases up to 60 C but the charger continues to operate; - The chargers are completely silent: no cooling fan or other moving parts. Reconditioning: A lead-acid battery that has been insufficiently charged or that has been discharged for days or weeks will deteriorate due to sulphation. If detected in time, the sulphation can sometimes be partially repaired by charging the battery with low current up to a higher voltage. Recovery function for fully discharged batteries: Most chargers with reverse polarity protection do not detect a battery that has become fully discharged or close to zero volts and therefore do not charge the battery. However, the Blue Smart IP65 charger will attempt to charge a fully discharged battery at a low current and resume normal charging once sufficient voltage is reached across the battery terminals. VictronConnect App: Install, read and configure your Blue Smart IP65 charger via your smartphone. You can view the status of your charger and battery and even check the functionality of your charger using the VictronConnect app. By default, you can read the voltage and current on the screen. Storage mode: Less corrosion on the positive plates Even the lower float charge voltage, which follows the absorption period, causes grid corrosion. It is therefore important to reduce the charging voltage even more when the battery remains connected to the charger for more than 48 hours. Temperature-compensated charging: The optimal charging voltage of a lead-acid battery varies inversely with temperature. The Blue Smart IP65 charger measures the ambient temperature during the test phase and compensates for temperature during the charging process. The temperature is measured again when the charger is set for low current during float or storage. Special settings for cold or hot environments are therefore not necessary. Lithium-ion battery mode: The Blue Smart IP65 charger uses a specific charging algorithm for lithium-ion batteries (LiFePO4), with automatic lithium-ion under voltage protection reset.