Victron MultiPlus 12/3000 / 120-16 230V VE.Buss

Victron MultiPlus 12Volt 3000VA 120A charging current 230V VE.Bus Two AC outputs The main output has an uninterruptible function. The MultiPlus takes over supply to the connected loads in the event of a grid failure or when shore/generator power is disconnected. This happens so quickly (within less than 20 milliseconds) that computers and other electronic equipment will continue to operate without interruption. The second output is energized only when AC power is available at one of the MultiPlus inputs. Loads that should not discharge the battery, such as a water heater, can be connected to this output (a second output is only available for models with a capacity of 3 kVA or more). Virtually unlimited power thanks to parallel operation Up to 6 Multis can operate in parallel to achieve higher power output. Six units 24/5000/120, for example, will provide 25kW/30kVA output power and 720 A charging capacity. Three-phase capacity In addition to parallel connection, three units of the same model can be configured for three-phase output. But that's not all: up to 6 sets of three units can be connected in parallel for a large inverter of 75 kW / 90 kVA and a charging capacity of more than 2,000 A. PowerControl MultiPlus 24/3000/70 Managing limited generator, shore or grid power. The MultiPlus is a very powerful battery charger. It will therefore draw a lot of current from the generator or shore supply (almost 10 A per 5 kVa Multi at 230 VAC). The Multi Control Panel allows you to set a maximum generator or shore power. The MultiPlus will then take into account other AC loads and use any extra current for charging, preventing the generator or shore power from being overloaded. PowerAssist Boost shore or generator power capacity This feature takes the principle of PowerControl to a new dimension. It enables the MultiPlus to extend the capacity of the alternative source. As peak power is often only required for a limited period, the MultiPlus will ensure that insufficient shore or generator power is immediately compensated with power from the battery. When the load decreases, the excess current is used to recharge the battery. Solar energy: AC power is available even during grid failure MultiPlus can be used without grid power, as well as with grid-connected PV and other alternative energy systems. A grid loss detection software is available. System configuration In the case of a stand-alone unit where settings need to be changed, this can be done in a few minutes with a new DIP switch setting procedure. MultiPlus Compact 12/2000/80 Parallel and three-phase units can be configured using VE.Bus Quick Configure and VE-Bus System Configurator software. Off-grid, grid-interactive and self-consumption units, including grid-connected inverters and/or MPPT solar chargers, can be configured with wizards (dedicated software for specific applications). On-site monitoring and control Several options are available: Battery monitor, Multi Control panel, Color Control GX and other GX devices, smartphone or tablet (Bluetooth Smart), laptop or desktop computer (USB or RS232). Remote monitoring and control Color Control GX and other GX devices. Data can be stored and viewed on our free Victron Remote Management (VRM) website. Remote Configuration When connected to Ethernet, systems with a Color Control GX and other GX devices can be accessed and settings can be changed.